Views: 0 Author: Site Editor Publish Time: 2022-11-10 Origin: Site
Geotextile is a permeable geosynthetic material made of synthetic fibers by needling or weaving. Geotextile is one of the new material geosynthetics, finished in the form of cloth, generally 4-6 meters in width and 50-100 meters in length. Geotextile fabric is divided into spun geotextile fabric and non-woven polypropylene geotextile fabric, which has the following characteristics.
1. High strength, due to the use of plastic fiber, Geotextile can maintain full strength and elongation in both wet and dry conditions. So it can be used as ground stabilization fabric.
2. Corrosion resistance, long-lasting corrosion resistance in soil and water of different acidity and alkalinity.
3. Good water permeability, there are voids between the fibers, so it has good water permeability.
4. Good anti-microbial properties, not damaged by microorganisms and insects.
5. Convenient construction, because the material is light and soft, it is easy to transport, lay, and construct.
Here is the content list:
How to properly lay geotextiles?
How to splice geotextile?
Geotextile rolls should be protected from damage before they are installed and unrolled. The geotextile rolls should be stacked in a place that is leveled and not waterlogged, at a height of no more than four rolls, with the identification piece of the roll visible. Geotextile rolls must be covered with opaque material to prevent UV deterioration. During storage, keep the label intact and the information intact. During transport, geotextile rolls must be protected from damage. Geotextile rolls that have been physically damaged must be repaired. Geotextiles subject to severe abrasion must not be used. Any geotextile that has been exposed to leaking chemicals is not allowed to be used on the project. When laying geotextiles, they should be rolled by hand, and the surface should be flat with appropriate deformation allowance.
Secondly, the installation of long or short filament geotextiles is usually done by several methods, such as lap, stitching, and welding. The width of stitching and welding is generally 0.1m or more, and the width of the lap is generally 0.2m or more. Geotextiles that may be exposed for a long time should be welded or stitched.
The installation of long or short filament geotextiles is usually done by several methods: lap, stitching, and welding. The width of stitching and welding is generally 0.1m or more, and the width of the lap is generally 0.2m or more. Geotextiles that may be exposed for a long time should be welded or stitched. In construction, hot air welding is the preferred method of joining filament geotextiles, i.e., the connection of two pieces of cloth is instantly heated at a high temperature with a hot air gun, so that their parts reach a molten state, and a certain external force is immediately used to make them firmly bonded together. In the case of wet weather that can not be a hot sticky connection, geotextile should take another method a stitching connection method, that is, a special sewing machine for double-line stitching connection, and the use of chemical UV-resistant stitching thread. For sewing connection, the same quality of sewing thread as geotextile should be used, and the sewing thread should be made of a material with stronger resistance to chemical damage and ultraviolet light exposure.
Our company has developed a wide range of Geotextiles which are tested extensively before leaving the factory to ensure quality. These Geotextiles are durable. If you want to buy Geotextile, you can consider our cost-effective products. Our company website is https://www.yfgeosynthetics.com/, please feel free to inquire about us!
